SMART IO-BRIDGE: SMALL MACHINE SIZES MASTER/SLAVE CONTROLLERS

description smart io-xxx is a family of low cost programmable controllers for specific functions where a low number of input/outputs is required. available with different hardware configurations, they allow to solve any requirements into a distributed can networks where simplicity and versatility are a must. despite that, these controllers are designed with double microprocessor hardware
architecture, to meet safety certification according to iso en13849.
they are programmable using c language or iec 61131, vt3 software development tool.

available versions
smart io-bridge
double microprocessor controller, configurable inputs and - pwm-bridge outputs, to control electric pwm motors with movement inversion control.

applications
- small on/off or pwm hydraulic systems control
- slave module for can multiplex systems
- electric motor drive small/medium size
- safety hydraulic systems controller according to en 13849 (up to pl-c)
- gangways controller
- slave module for spreaders

inputsoutputs	configuration	nr. i/o
multifunctional inputs	software configurable:	6
	- analog 0 - 30 v, 12 bit
	- analog 0 - 5.5 v, 12 bit
	- analog 0 - 25 ma, 12 bit
	- digital high side
multifunctional inputs	software configurable:	0
	- analog 0 - 5.5 v, 12 bit
	- variable resistance 0 - 2500 ohm
	- digital high side/low side
multifunctional inputs	software configurable:	2
	- analog 0 - 30 v, 12 bit
	- analog 0 - 5.5 v, 12 bit
	- digital high side
multifunctional inputs	software configurable:	2
	- rpm frequency: high side/low side, 0 -12khz
	- digital: high side/low side
digital input	- digital high side	0
digital input	- digital low side	0
digital input	software configurable	0
	-digital high/low side
power output	digital output with diagnostic:	2
	- on/off: high side, 2 a
power output	software configurable with diagnostic:	2
	- on/off: high side, 2 a
	- pwm: 50 - 500hz duty cycle, 2 a
power output	digital output with diagnostic:	0
	-on/off low side, 1 a
power output	full bridge with diagnostic, 4 a	2
auxiliary outputs	power supply for sensors with voltage feedback:	1
	- 1 line at 5 v, 100 ma