FOLLOW US:

  • Original product

VIEW 2 DISPLAY LIMIT. HOR. 5.7 SW HCW_002

3B6 (Original product)
1031985

Code: 43.31.3101A4.01

Request quotation
Add to Wishlist
  • SSL 100% secure website SSL 100% secure website
  • Fast shipping with national and international couriers Fast shipping with national and international couriers
Sito sicuro | Pagamento sicuro
Description VIEW 2 is a monitor with a 5.7” QVGA (320x240) display with LED technology, equipped with Freescale 16 bit processor and FPGA graphic accelerator. This architecture allows high performance, like 32bit processor based devices, but at lower cost. It is provided with an integrated 16 keys keypad, and it allows installation in landscape mode (horizontal) or portrait (vertical).
VIEW 2 is an ideal solution to show parameters, data or any information available on the CAN network of the machine where it is installed.
VIEW 2 can be also equipped with an additional board with several I/O, making it a real controller easily programmable for I/O logic management and integrated graphics.
VIEW 2 is fully programmable using VT3 software development tool, COBO proprietary IDE, that combines intuitive WYSIWYG graphic programming with IEC61131 standard. VIEW 2 can be installed both in-dash or out-dash with its specific articulated support.

APPLICATION

- Display for load limiting device for any type of crane or Lifting machine
- Concrete pumps
- Crushers
- Small access platforms
- Small size agriculture tractors
- Dashboard for telehandlers or reachstackers
POWER SUPPLY VOLTAGE
9 - 30V 
HOUSING
ABS with silicon rubber
OPERATING TEMPERATURE
- 20° C ÷ + 70° C (- 4° F ÷ + 158° F)
STORAGE TEMPERATURE
- 35° C ÷ + 85° C (- 31° F ÷ +185° F)
SEALING
IP65
DISPLAY TFT
Colour display 5.7”, 256 or 65K colours 
- Resolution 320 x 240 pixels
- Viewing angle 130°, horizontal and vertical
- Contrast Ratio: 400:1
- Brightness 800 cdm
- Backlight type: White Led
- Landscape or portrait installation
CONTROL SYSTEM
- Microprocessor Freescale 16bit, 40 MHz
- Graphic accelerator on FPGA Atmell 
- RAM memory 512KB
- Flash memory 1.2 MB
- EEPROM 8KB for Parameters Storage
- Real time clock with 240 byte RAM and rechargeable backup battery
- 1 SD card slot on panel (up to 2Gb)
CONNECTIVITY
- 2 CAN-BUS, CAN 2.0B (11 or 29-bit), ISO 11898-2 compliance, speed up to 1 Mbit/s
- 1 serial lines standard RS232
- 1 buzzer
SOURCE I/O
- 12 analog/digital inputs configurable
- 6 on/off outputs (2A at 24V)
APPLICATIONS
Components for access platforms telescopic - cranes
Telehandlers
Forklift trucks
Earth moving machines
Trucks tractors - trailers
Agricultural vehicles
Combines
Mixer wagons
Fire fighting - rescue vehicles
Camper & caravan
Motorcycles - quad components
Electric vehicles - golf cart
Can-bus boat global control system
Ambulances - emergency vehicles
Defense vehicles
1031985